Would suggest you swap connectors to keep the joy…
pretty sure it was loose fitting pins In the connector.
and the only way I persevered through that entire debacle was…...
Xplitive
U-joint
Last Activity: 03-19-2023, 09:20 AM
Joined: 05-15-2016
Location: “Yorktown” Virginia
-
Last edited by Xplitive; 03-17-2023, 01:49 AM. -
New favorite show!!...Leave a comment:
-
Since the initial start, the sniper hasn’t…
Here is a thread on it detailing the troubleshooting and fix.
https://forums.holley.com/forum/holl...2-autolite-110...Leave a comment:
-
That is an awesome rig! Was it straight forward fitting the bulkhead and rest of the body on? Where was the fuel tank?Leave a comment:
-
Well up and running.
Idling pretty high at the moment and reading manual on how to get the IAC to come down. It’s at 20% and isn’t responding to adjustments in the idle...Leave a comment:
-
watched the video, Interested to hear what the problem is. Brakes not bleeding, new parts that aren’t really round, or maybe the shoe not on the post properly. … and lately I’ve only...Leave a comment:
-
[QUOTE=dporter110;n211148]I just received one from a batch that had poor machine work on the mating surface (not flat with grinding marks). It would work but they are aware of the issue and offered to...Leave a comment:
-
Tom, thanks! waiting for shipping confirmation before deleting this post....Leave a comment:
-
Bob and Mark, thanks again for the education. A few more years of this and I’ll at least have an associates degree....Leave a comment:
-
Sold out at the moment. In a bit of a pinch and seeing if anyone has a kit they aren’t getting around to installing....Leave a comment:
-
ISO Holley Autolite Sniper
If there are any Holley Sniper Autolite kits sitting around looking for a new home, please let me know. -
Looked at 2 local 88’s over the past year or two. One was in Virginia Beach, supposedly from New Zealand, white with black truck cab. Looked extremely nice paint wise. The frame was patched on patches...Leave a comment:
-
Switched 12V ignition in crank & run
S3 petrol. Sniper install.
Best place to look for switched power in crank and run?
looking at the back of the ignition switch and, of course, it’s 5 terminals instead 4. The extra... -
Yes! Sent message.Leave a comment:
-
The middle piece on the top is the filler panel bottom left hand wing. Most of that stuff should be readily available, and galvanized, from multiple sources. Check YRM, emberton imperial, RN for pricing...Leave a comment:
-
Also in, should you decide to make a run.
the freaking temp sender has been an interesting beast.
While waiting for LR adapters to come back in stock, found readily available drill arbors...Leave a comment:
-
Thinking of production?Leave a comment:
-
It was actually specified in the instructions that the oil one needed to be leads up....Leave a comment:
-
Living dangerously, you’ve been over 70 mph in a Series more times than any one with a will to live.Leave a comment:
-
Because my coil leads face down, went with the epoxy version (40611). Had called NGK asking about an off the shelf 3.0 ohm canister coil. Got a number to call, maybe should.....Leave a comment:
No activity results to display
Leave a comment: