Forester
Crossmember
Last Activity: Today, 04:25 PM
Joined: 10-21-2010
Location: Brewer, Maine
-
-
In this day and age it might be cheaper to ship then for me to drive to Portland LOL -
John,
I need the transmission case and the cover that goes over the selector rods. Apparently this cover has to come off the case that it was origionally mounted on or it will not fit. Don't know... -
I need the cover that goes over the selector rods. Apparently it has to be matched with the transmission case it came off from so I need a "new" case as well....Last edited by Forester; 11-20-2023, 08:33 PM.Leave a comment:
-
2a Transmission Bits
I am looking for the housing with the rear mainshaft bearing retainer and top cover for a Series 2a. I don't need any of the internals or the bell housing. 50 wulf has a trans in Mississippi but looking... -
Sending you a PM.
JimLeave a comment:
-
Turner in the UK has them as well.
https://www.turnerengineering.co.uk/...ed-c2x20823022Leave a comment:
-
Resurrected
What better to go with my Rover than a Coleman lantern of approximately the same vintage. My Dad purchased it sometime in the late 60's for family camping trips. We had two, a single mantle and this double.... -
I have the same brake light switch on my Rover. It has been fairly bullet proof and reliable plus I found the there is a switch for a Jeep which works fine and was less than $10. I keep a spare in the...Leave a comment:
No activity results to display
Leave a comment: