Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Probably the best thing to do would be to check if the part numbers match or not.
-
The box edge has to be 90 degree to the door sill prior to measuring the 34.75 to the bulkhead. Otherwise you end with a parallelogram shaped door opening. Not a good thing.
Leave a comment:
-
-
-
One of the local shops advertises the beads, mostly geared toward semi trucks. It would be nice to hear some input on the technology and if it applies to Rover type vehicles. Might have to stop by and...
Leave a comment:
-
No tubes that I recall, been 20 years so maybe I just forget. CRS sometimes comes into play.
I have a local shop that should be able to balance for me, I hope.Last edited by 64osby; 01-05-2023, 09:40 AM.
Leave a comment:
-
Mounting tires
I've not put tires on my Rover for about 20 years, it sat for about 10 years.
Almost ready to start test driving and have tires to replace my weather checked ones.
As I recall...
-
Looks like something that could be milled instead of cast to me. No expert as I am a shadetree engineer.
Leave a comment:
-
Just a minor issue with my seal
I think that was a blue bag part. Had an old stock Karson's and installed it. Hoping it stays together.
I probably damaged...
Leave a comment:
-
I guess I should not have posted about our Element. A few nights ago someone decided they needed the Element cat more than we did. Flipping arsholes!
He was parked at a friends house during...
Leave a comment:
-
IMHO that is a design issue not an overload issue. I have seen many of these on the web lately.
Edit, yes it probably (definitely) overloaded. I still say there is a design issue. There...Last edited by 64osby; 12-31-2022, 03:13 AM.
Leave a comment:
-
I looked today and only have a readable mark on the front. I did change the alignment so both yolks were aligned. Is there another way ?
Removed the spline cover that I had put on the rear...
Leave a comment:
-
Lights in the breakfast ended in '69 I believe. I would call it a late 2a based on the mirrors, those are not '62 mirrors, '67 to '69 would be my guess. Santana? Who knows.
Leave a comment:
-
I would guess it is due to old grease, dirt and the cold causing the throw out to stick. The other issue could be it was to slow to slide out, cold / low battery, maybe a combination of the two.
...
- 1 like
Leave a comment:
-
Made another video of the drive train noise. It think I'll be checking the rear prop shaft bolts and the drive flange nut tension at the same time.
https://youtu.be/aqNAZDu4LJY
Leave a comment:
-
You might want to see if there is a local paint stripper (dip tanks). That could strip it before having it galvanized.
On my project I was able to find a super clean used frame. It had a...
Leave a comment:
-
Saw this article today about an opposed engine. When I hear that term I think of the Subaru box four. This is much different.
https://www.motorbiscuit.com/cummins...0-horsepower-e...
Leave a comment:
No activity results to display
Show More
Leave a comment: