siiirhd88
Cogwheel
Last Activity: Today, 05:26 AM
Joined: 10-22-2010
Location: York County, Pa. and Beaufort, NC.
-
Looks good and I also noted the intake was quieter.... -
I had the same thing on the TR-3 when the ignition coil failed. It would start and run OK except under load or hard acceleration when it would break up.
BobLeave a comment:
-
Maybe the diff is used in a non-automotive application. I remember seeing an old Ford three speed manual trans connected to an electric motor, with the trans output yoke and U-joint connected to a rear...Leave a comment:
-
The one from my late SIII is 2 5/8" I.D. on the round end and the oval end squeezed round measured about the same. The length as it sat with nothing in either end is 14 1/2", but it does expand...Leave a comment:
-
Nah, the facilities are way too modern....Leave a comment:
-
Pedal tower is on the way. Thanks.
BobLeave a comment:
-
I have one available. I'll be back in Pa. tomorrow and will try to post a pic tomorrow evening.
BobLeave a comment:
-
I think the shorter bolts would be fine using the Defender retainer. I used a piece of angle to span the center hole on the wheel with holes drilled to match the pie plate and used the longer of the...Leave a comment:
No activity results to display
Leave a comment: